Page Comparison

All the needed calculation steps are not executed.

Solution: When the scope,

business rules, or

objectives

change, the

Run step will have to be executed again to compute the new results. After that, executing the

Results step is needed to update the visualizations.

Check the source data

.

Often there is no filtering step to remove redundant/misleading inputs or data that do not fit the scope of the problem. Ensure that

you work with a correct subset of data and if the behavior persists, look into the tables to find the explanation with the

ID of the involved points.

“Some Value Finders are still moving fast with unsatisfied

neighbors”, it means that the OE

needs more steps to find the solution. This is especially true if this applies to a large portion of the

Value Finders.

Solution: Change the number accordingly and start a new run.

Possible cause 1: The constraint is not tuned enough

.

Solution: Increase the priority of the constraint, check its target value and the minimum steps of the

Value Finder.

Possible cause 2: Over-constrained problem: if the OE job says that

“Some Value Finders are very close to their boundaries and may be stuck

there”, it means that the solution of the problem is outside its research space.

• We can still pinpoint what

• these problematic constraints

• are and what elements are

• affected.

• We can, if

• it makes business sense, adjust other constraints to make

• room for

• optimization.

• Define with the client what are the most important

• constraints to satisfy.

Note: Do not hesitate to test some runs with more lenient constraints: people will often try to put more constraints than needed, by trying to predict the impact of a modification somewhere and applying their expected results on the intermediate steps from the product the target aggregation. More often than not it will only restrict the optimization space for no gain.

Possible cause 3: Over-constrained problem from conflicting objectives. Two or more constraints push the system in

irreconcilable directions, and it settled at the best compromise it could.

For example, a constraint that aims to reduce the list price and a constraint that aims to increase its margin.

Check:

The “Unacceptable” lines in the results tables to validate that other constraints

conflict with the one

you are working on.

Solution:

With feedback from the domain, decide if you have to modify some constraints or to add an exception for specific agents (e.g.

not optimizing for some specific product).

The objectives/constraints are not precise enough.

Solution:

Fine-tune the objectives' precision (acceptable_delta, target…)

using the previous results.

Possible cause: Some domain rules are not modeled yet. It can be the case when a client forgets to state some constraints

they consider as obvious, such as “price cannot drop” or “margin must increase”.

Solution: Loop with the client to ensure that the domain is fully

modeled and that the constraints have the correct type (e.g. target instead of threshold

).