Aim of this section | Shows how to create or edit a scheduler. |
|---|---|
Related sections | Schedulers (Reference Manual) |
Required permissions | Partition Event Orchestration - use |
...
Go to Account > Event Workflows > Schedulers.
Click Create Scheduler.
Fill in the following fields:
In the General section:
You can toggle the Status between Enabled and Disabled.
Enter Scheduler Name of your choice.
In the Target section you define where an action should take place.
Target Type – Select either Partition, Integration, or PFM.
Target Name – Select a particular partition or IM instance.
In the Action section you define what should be triggered.
Action Type – Defines what that type of action should run. Completion of this action can trigger a sequence of steps in a workflow.
For a partition you can select:
Logic
Calculation
Data Load
For integration you can select:
Route
For PFM you can select:
Workflow
Data Download (for more details, refer to Downloads)
Action ID – Select a specific logic / calculation / Data Load / route / partition. In case of multiple actions with the same name but different target, the target partition is displayed in parentheses after the action name.
In the Payload section define a payload content and send it as body.
In the Timing section set the start time and end time, specify the time zone, define the repeat frequency and intervals, and determine specific times for triggering actions.
Click Create to save the scheduler.
Once it is created, you can turn it on/off also from the list of schedulers.